Calibrating your torque tool
Check your torque tools
In line with standard ISO 6789-1, torque tools must be calibrated at the time of manufacture, then every year or every 5,000 cycles after first being put into service by the user.
SAM OUTILLAGE helps you to carry out these tasks throughout your torque tool's lifetime.
Thanks to our verification bench calibrated by LNE (COFRAC-approved), we can carry out the verifications on tools going from 0.2 to 2000 Nm, in compliance with the latest standard NF EN ISO 6789-1.
Calibration services for your SAM torque tools
SAM Outillage proposes 3 types of calibration per utilisation direction (right or left)
3-point calibration
- 3-point tool check: min. torque, 60 and 100% of the tool's maximum capacity
- 5 measurements per point
- Declaration-of-conformity printout
10-point calibration
- 10-point tool check: every 10% of the tool's maximum capacity
- 5 measurements per point
- Declaration-of-conformity printout
1-point calibration (single-torque)
- Tool setting to a particular torque value
- Declaration-of-conformity printout

Example of a declaration of conformity
Calibration-at-manufacture services for your SAM torque tools
All our mechanical tools (except single-torque) are supplied with a declaration of conformity covering 3 points in 1 direction.
All our electronic tools are supplied with a declaration of conformity covering 3 points in both directions.
If you want a 10-point declaration of conformity when you place your order as per the latest standard NF EN ISO 6789-1, this service will be invoiced to you (reference to be given: ETAL-NEUF).
All-in calibration packages for your SAM torque tool
Mechanical tools: expert appraisal, setting, declaration-of-conformity printout.
- Ranges: DYNATECH®, DYNASTOP®, DYNALEC®, DYNAPROD®, DYNAVIS®.
Electronic tools and measuring instruments: expert appraisal, setting (tightening and loosening), declaration-of-conformity printout.
- Ranges: DYNALIGHT® A, DYNALIGHT® C, DYNALIGHT® FORCE, DYNATEST®.
Your distributor will submit a quote for the repair of your tool (if a repair is required).

All-in calibration packages
All-in packages excluding repair | 3-point declaration of conformity |
10-point declaration of conformity |
1-point declaration of conformity |
---|---|---|---|
Mechanical tools adjustable from 0.2 to 2,000 Nm | |||
Electronic tools and measuring instruments adjustable from 0.2 to 1,000 Nm | |||
Adjustable mechanical screwdrivers | |||
Single-torque mechanical tools |